Construction. . .
Inside the GPRH heater is a rugged, power limiting type
heating cable affixed and spaced to provide a uniform
temperature profile across the inside surface of the top
heater panel. The heater cable is secured in place on the
panel with 2” aluminum tape. The 6 foot long heater
cold lead is terminated inside the unit and exit through
the end of the heater.
A single layer of 3/8” silicone foam is laid over top of the
heater cable and terminations covering the entire
internal area.
The lid and panel shall be held together using the steel
piercing rivets applied with a rivet stamping press.
GPRH heaters shall be painted with light gray epoxy as
specified by the customer and marked with red lettering
three inches (3“) high. The lettering shall say “DANGER-
HIGH VOLTAGE-THIS SIDE UP”.
Further red lettering shall be one inch (1”) high stating
“RHPS” and the heater model number. The model
number, heater wattage @ operating voltage and
company name shall also be stated on tag located on
top side of heater near cold leads. Heater voltage shall
be printed on a metallic tag attached to the cold lead.